AudioCodes MediaPack MP-118 User Manual

Version 6.6 395 MP-11x & MP-124
User's Manual 38. Syslog and Debug Recordings
ITU Perceived Severity
(SNMP Alarm’s Severity)
AudioCodes' Syslog Severity
Cleared
Notice

Cleared Alarms: CLEAR-ALARM: <Alarm Name>; Textual Description: <Textual
Description>; Severity <Alarm Severity>; Source <Alarm Source>; Unique ID: <Alarm
Unique ID >; If exists Additional Info1:/ Additional Info2:/ Additional Info3:
38.2 Configuring Syslog Settings
The procedure below describes how to configure Syslog. This includes defining the Syslog
server address as well as selecting the activities on the device (for example, a parameter
value change) that you want reported to the server.
Notes:
• For configuring CDR reporting, see 'Configuring CDR Reporting' on page
376.
• For viewing Syslog messages in the Web interface, see 'Viewing Syslog
Messages' on page 398.
• For a detailed description on the Syslog parameters, see 'Syslog, CDR
and Debug Parameters' on page 441.
 To configure Syslog :
1. Open the Syslog Settings page (Configuration tab > System menu > Syslog
Settings).
2. Enable the Syslog feature by setting the 'Enable Syslog' to Enable.
3. Define the Syslog server using the 'Syslog Server IP Address' and 'Syslog Server Port'
parameters.

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet