AudioCodes MediaPack MP-118 User Manual

Version 6.6 549 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
(applicable to FXO interfaces):
 SITDetectorEnable = 1
 UserDefinedToneDetectorEnable = 1
 DisconnectOnBusyTone = 1 (applicable for busy, reorder,
and SIT tones)
Note: For this parameter to take effect, a device reset is
required.
EMS: UDT Detector Frequency
Deviation
[UDTDetectorFrequencyDeviation]
Defines the deviation (in Hz) allowed for the detection of each
signal frequency.
The valid range is 1 to 50. The default is 50.
Note: For this parameter to take effect, a device reset is
required.
EMS: CPT Detector Frequency
Deviation
[CPTDetectorFrequencyDeviation]
Defines the deviation (in Hz) allowed for the detection of each
CPT signal frequency.
The valid range is 1 to 30. The default is 10.
Note: For this parameter to take effect, a device reset is
required.
43.10.7.3 Metering Tone Parameters
The metering tone parameters are described in the table below.
Table 43-54: Metering Tone Parameters
Parameter Description
Web: Generate Metering
Tones
EMS: Metering Mode
[PayPhoneMeteringMode]
Determines the method used to configure the metering tones that are
generated to the Tel side.
 [0] Disable = (Default) Metering tones aren't generated.
 [1] Internal Table = Metering tones are generated according to the
device's Charge Code table (using the ChargeCode parameter).
Notes:
 This parameter is applicable only to FXS interfaces.
 If you select 'Internal Table', you must configure the Charge Codes
table, using the ChargeCode parameter (see Configuring Charge
Codes Table on page 263).
Web: Analog Metering
Type
EMS: Metering Type
[MeteringType]
Determines the metering method for generating pulses (sinusoidal
metering burst frequency) by the FXS port.
 [0] 12 KHz = (Default) 12 kHz sinusoidal bursts.
 [1] 16 KHz = 16 kHz sinusoidal bursts.
 [2] = Polarity Reversal pulses.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to FXS interfaces.

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet