AudioCodes MediaPack MP-118 User Manual

User's Manual 570 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
RoutingRuleGroups_LCREnable,
RoutingRuleGroups_LCRAverageCallLength,
RoutingRuleGroups_LCRDefaultCost;
[ \RoutingRuleGroups ]
Note: For a detailed description of this table, see 'Enabling LCR and
Configuring Default LCR' on page 167.
Web: Cost Group Table
EMS: Cost Group
Provisioning > Cost Group
[CostGroupTable]
This table parameter configures the Cost Groups for LCR, where each
Cost Group is configured with a name, fixed call connection charge,
and a call rate (charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
Note: For a detailed description of this table, see 'Configuring Cost
Groups' on page 169.
Web: Cost Group > Time
Band Table
EMS: Time Band
Provisioning > Time Band
[CostGroupTimebands]
This table parameter configures time bands and associates them with
Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
Note: For a detailed description of this table, see 'Configuring Time
Bands for Cost Groups' on page 170.
43.12 Standalone Survivability Parameters
The Stand-alone Survivability (SAS) parameters are described in the table below.
Table 43-62: SAS Parameters
Parameter Description
Web: Enable SAS
EMS: Enable
[EnableSAS]
Enables the Stand-Alone Survivability (SAS) feature.
 [0] Disable (default)
 [1] Enable
When enabled, the device receives the registration requests
from different SIP entities in the local network and then forwards
them to the defined proxy. If the connection to the proxy fails
('Emergency Mode'), the device serves as a proxy by allowing
calls internal to the local network or outgoing to PSTN.
Note: For this parameter to take effect, a device reset is
required.
Web: SAS Local SIP UDP Port
EMS: Local SIP UDP
[SASLocalSIPUDPPort]
Defines the local UDP port for sending and receiving SIP
messages for SAS. The SIP entities in the local network need to
send the registration requests to this port. When forwarding the
requests to the proxy ('Normal Mode'), this port serves as the

AudioCodes MediaPack MP-118 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-118
Category	Gateway
Language	English