AudioCodes MediaPack MP-118 User Manual

User's Manual 356 Document #: LTRT-65422
MP-11x & MP-124
32.6 Remotely Triggering Auto Update using SIP NOTIFY
The device can be remotely triggered to start the Automatic Update process upon receipt
of a SIP NOTIFY that includes an Event header set to 'check-sync;reboot=false', as shown
in the example below:
NOTIFY sip:<user>@<dsthost> SIP/2.0
To: sip:<user>@<dsthost>
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=false
For this feature to function, Automatic Update must be enabled on the device. In other
words, it must have a loaded ini file with the Automatic Update settings.
 To enable remote trigger of Auto Update upon receipt of SIP NOTIFY:
1. Open the Advanced Parameters page (Configuration tab > VoIP menu > SIP
Definitions > Advanced Parameters).
2. Under the Misc Parameters group, set the 'SIP Remote Reset' parameter to Enable.
3. Click Submit.
Note: This SIP Event header value is proprietary to AudioCodes.

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet