Notes:
This parameter is applicable only to FXS interfaces.
To enable the device to send a 183/180+SDP responses,
set the EnableEarlyMedia parameter to 1.
If the EnableDigitDelivery parameter is set to 1, the device
doesn't play a ringback tone to IP and doesn't send 183 or
180+SDP responses.
This parameter can also be configured in an IP Profile.
Tone Index Table
Web: Tone Index Table
EMS: Analog Gateway Provisioning >
Tone Index
[ToneIndex]
This table parameter configures the Tone Index table, which
allows you to define distinctive ringing and call waiting tones
per FXS endpoint (or for a range of FXS endpoints).
The format of this parameter is as follows:
[ToneIndex]
FORMAT ToneIndex_Index = ToneIndex_FXSPort_First,
ToneIndex_FXSPort_Last, ToneIndex_SourcePrefix,
ToneIndex_DestinationPrefix, ToneIndex_PriorityIndex;
[\ToneIndex]
For example, the configuration below plays the tone Index #3
to FXS ports 1 and 2 if the source number prefix of the
received call is 20.
ToneIndex 1 = 1, 2, 20*, , 3;
Note: For a detailed description of this table, see Configuring
FXS Distinctive Ringing and Call Waiting Tones per
Source/Destination Number.
43.10.7.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.
Table 43-53: Tone Detection Parameters
Parameter Description
EMS: DTMF Enable
[DTMFDetectorEnable]
Enables the detection of DTMF signaling.
[0] = Disable
[1] = Enable (default)
EMS: MF R1 Enable
[MFR1DetectorEnable]
Enables the detection of MF-R1 signaling.
[0] = Disable (default)
[1] = Enable
EMS: User Defined Tone Enable
[UserDefinedToneDetectorEnable]
Enables the detection of User Defined Tones signaling,
applicable for Special Information Tone (SIT) detection.
[0] = Disable (default)
[1] = Enable
EMS: SIT Enable
[SITDetectorEnable]
Enables SIT detection according to the ITU-T recommendation
E.180/Q.35.
[0] = Disable (default)
[1] = Enable
To Next Page
Loading...
