AudioCodes MediaPack MP-118

Version 6.6 541 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
43.10.6 Answer and Disconnect Supervision Parameters
The answer and disconnect supervision parameters are described in the table below.
Table 43-51: Answer and Disconnect Parameters
Parameter Description
Web: Answer Supervision
EMS: Enable Voice Detection
[EnableVoiceDetection]
Enables the sending of SIP 200 OK upon detection of
speech, fax, or modem.
 [1] Yes = The device sends a SIP 200 OK (in response
to an INVITE message) when speech, fax, or modem is
detected.
 [0] No = (Default) The device sends a SIP 200 OK only
after it completes dialing.
Typically, this feature is used only when early media
(enabled using the EnableEarlyMedia parameter) is used
to establish the voice path before the call is answered.
Note: This feature is applicable only to one-stage dialing
(FXO).
Web/EMS: Max Call Duration (min)
[MaxCallDuration]
Defines the maximum duration (in minutes) of a call. If this
duration is reached, the device terminates the call. This
feature is useful for ensuring available resources for new
calls, by ensuring calls are properly terminated.
The valid range is 0 to 35,791. The default is 0 (i.e., no
limitation).
Web/EMS: Disconnect on Dial Tone
[DisconnectOnDialTone]
Determines whether the device disconnects a call when a
dial tone is detected from the PBX.
 [0] Disable = (Default) Call is not released.
 [1]
Enable = Call is released if a dial tone is detected on
the device's FXO port.
Notes:
 This parameter is applicable only to FXO interfaces.
 This option is in addition to the mechanism that
disconnects a call when either busy or reorder tones are
detected.
Web: Send Digit Pattern on Connect
EMS: Connect Code
[TelConnectCode]
Defines a digit pattern to send to the Tel side after a SIP
200 OK is received from the IP side. The digit pattern is a
user-defined DTMF sequence that is used to indicate an
answer signal (e.g., for billing).
The valid range is 1 to 8 characters.
Note: This parameter is applicable to FXO.
Web: Disconnect on Broken Connection
EMS: Disconnect Calls on Broken
Connection
[DisconnectOnBrokenConnection]
Determines whether the device releases the call if RTP
packets are not received within a user-defined timeout.
 [0] No
 [1] Yes (default)
Notes:
 The timeout is configured by the
BrokenConnectionEventTimeout parameter.
 This feature is applicable only if the RTP session is
used without Silence Compression. If Silence
Compression is enabled, the device doesn't detect a