AudioCodes MediaPack MP-118

User's Manual 540 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
 Double-wink signaling [2]: interval between the first and second wink.
 Wink and Polarity signaling [3]: interval between wink and polarity
change.
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the wink
signaling type.
Web/EMS: Delay Before
DID Wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
EMS: NTT DID Signalling
Form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices
can be connected to Japan's NTT PBX using 'Modem' DID lines. These
DID lines are used to deliver a called number to the PBX.
 [0] = (Default) FSK-based signaling
 [1] = DTMF-based signaling
Note: This parameter is applicable only to FXS interfaces.
EMS: Enable DID
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX.
The DID signal can be sent alone or combined with an NTT Caller ID
signal.
The format of this parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable;
[\EnableDID]
Where,
 Index = Port number (where 0 denotes Port 1).
 IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem
DID support.
For example:
EnableDID 0 = 1; (DID is enabled on Port 1)
Note: This parameter is applicable only to FXS interfaces.
[WinkTime]
Defines the time (in msec) elapsed between two consecutive polarity
reversals. This parameter can be used for DID signaling.
The valid range is 0 to 4,294,967,295. The default is 200.
Notes:
 This parameter is applicable to FXS and FXO interfaces.
 For this parameter to take effect, a device reset is required.