37.2.2 CDR Field Description
This section describes the CDR fields that are generated by the device.
37.2.2.1 CDR Fields for Gateway/IP-to-IP Application
The CDR fields for the Gateway / IP-to-IP application are listed in the table below.
Table 37-2: CDR Fields for Gateway/IP-to-IP Application
Field Name Description
GWReportType
Report type:
ï‚§ CALL_START
ï‚§ CALL_CONNECT
ï‚§ CALL_END
Cid
Port number
SessionId
SIP session identifier
Trunk
Physical trunk number
Note: This field is applicable only to the Gateway application.
BChan
Selected B-channel (set to '0', as not applicable)
Note: This field is applicable only to the Gateway application.
ConId
SIP conference ID
Note: This field is applicable only to the Gateway application.
TG
Trunk Group ID
Note: This field is applicable only to the Gateway application.
EPTyp
Endpoint type:
ï‚§ FXO
ï‚§ FXS
ï‚§ EANDM
ï‚§ ISDN
ï‚§ CAS
ï‚§ DAA
ï‚§ IPMEDIA
ï‚§ NETANN
ï‚§ STREAMING
ï‚§ TRANSPARENT
ï‚§ MSCML
ï‚§ VXML
ï‚§ IP2IP
Orig
Call originator:
ï‚§ LCL (Tel side)
ï‚§ RMT (IP side)
SourceIp
Source IP address
DestIp
Destination IP address