AudioCodes MediaPack MP-118 User Manual

Version 6.6 57 MP-11x & MP-124
User's Manual 4. Web-Based Management
4.1.9 Creating a Login Welcome Message
You can create a Welcome message box that is displayed on the Web Login page for
logging in to the Web interface. The figure below displays an example of a Welcome
message:
Figure 4-22: User-Defined Web Welcome Message after Login
To enable and create a Welcome message, use the WelcomeMessage table ini file
parameter. If this parameter is not configured, no Welcome message is displayed.
Table 4-9: ini File Parameter for Welcome Login Message
Parameter Description
[WelcomeMessage]
Enables and defines a Welcome message that appears on the Web Login
page for logging in to the Web interface.
The format of this parameter is as follows:
[WelcomeMessage]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
[\WelcomeMessage]
For Example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
WelcomeMessage 1 = "*********************************";
WelcomeMessage 2 = "********* This is a Welcome message **";
WelcomeMessage 3 = "*********************************";
[\WelcomeMessage]
Each index row represents a line of text in the Welcome message box. Up
to 20 lines (or rows) of text can be defined.

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet