Version 6.6 415 MP-11x & MP-124
User's Manual 41. Testing SIP Signaling Calls
Figure 41-6: Batch Test Call Example
• Test Call table configuration at Device A:
♦ Endpoint URI: "101"
♦ Called URI: "201"
♦ Route By: Dest Address
♦ Destination Address: "10.13.4.12"
♦ Call Party: Caller
♦ Maximum Channels for Session: "3" (this setting configures three endpoints -
"101", "102" and "103)
♦ Call Duration: "5" (seconds)
♦ Calls per Sec: "1"
♦ Test Mode: Continuous
♦ Test Duration: "3" (minutes)
♦ Schedule Interval: "180" (minutes)
• Test Call table configuration at Device B:
♦ Endpoint URI: "201"
♦ Call Party: Caller
♦ Maximum Channels for Session: "3" (this setting configures three endpoints -
"201", "202" and "203)
Registration Test Call Scenario: This example describes the configuration for testing
the registration and authentication (i.e., username and password) process of a
simulated test endpoint on the device with an external proxy/registrar server. This is
useful, for example, for verifying that endpoints located in the LAN can register with an
external proxy and subsequently, communicate with one another.
To Next Page
Loading...
