Parameter Description
SNMP Community String Parameters
Community String
[SNMPReadOnlyCommunityString
_x]
Defines up to five read-only SNMP community strings (up to
19 characters each). The default string is 'public'.
Community String
[SNMPReadWriteCommunityStrin
g_x]
Defines up to five read/write SNMP community strings (up to
19 characters each). The default string is 'private'.
Trap Community String
[SNMPTrapCommunityString]
Defines the Community string used in traps (up to 19
characters).
The default string is 'trapuser'.
SNMP Trusted Managers Table
Web: SNMP Trusted Managers
[SNMPTrustedMgr_x]
Defines up to five IP addresses of remote trusted SNMP
SNMP Get and Set requests.
Notes:
By default, the SNMP agent accepts SNMP Get and Set
requests from any IP address, as long as the correct
community string is used in the request. Security can be
enhanced by using Trusted Managers, which is an IP
address from which the SNMP agent accepts and
processes SNMP requests.
If no values are assigned to these parameters any
manager can access the device.
Trusted managers can work with all community strings.
SNMP V3 Users Table
Web/EMS: SNMP V3 Users
[SNMPUsers]
This parameter table defines SNMP v3 users. The format of
this parameter is as follows:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey,
SNMPUsers_Group;
[\SNMPUsers]
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security
level authNoPriv(2), authentication protocol MD5,
authentication text password 'myauthkey', and
ReadWriteGroup2.
Note: For a description of this table, see 'Configuring SNMP
V3 Users' on page 84.
To Next Page
Loading...
Need help?
General
