AudioCodes MediaPack MP-118 User Manual

User's Manual 528 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
Notes:
 This parameter is applicable only for FXS interfaces.
 This parameter can also be configured in a Tel Profile.
Web/EMS: MWI Display
[MWIDisplay]
Enables sending MWI information to the phone display.
 [0] Disable = (Default) MWI information isn't sent to display.
 [1] Enable = The device generates an MWI message
(determined by the parameter CallerIDType), which is
displayed on the MWI display.
Note:
 This parameter is applicable only to FXS interfaces.
 This parameter can also be configured in a Tel Profile.
Web: Subscribe to MWI
EMS: Enable MWI Subscription
[EnableMWISubscription]
Enables subscription to an MWI server.
 [0] No (default)
 [1] Yes
Notes:
 To configure the MWI server address, use the MWIServerIP
parameter.
 To configure whether the device subscribes per endpoint or
per the entire device, use the parameter SubscriptionMode.
Web: MWI Server IP Address
EMS: MWI Server IP
[MWIServerIP]
Defines the MWI server's IP address. If provided, the device
subscribes to this IP address. The MWI server address can be
configured as a numerical IP address or as a domain name. If
not configured, the Proxy IP address is used instead.
Web/EMS: MWI Server Transport
Type
[MWIServerTransportType]
Determines the transport layer used for outgoing SIP dialogs
initiated by the device to the MWI server.
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: When set to ‘Not Configured’, the value of the parameter
SIPTransportType is used.
Web: MWI Subscribe Expiration
Time
EMS: MWI Expiration Time
[MWIExpirationTime]
Defines the MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 2,000,000.
Web: MWI Subscribe Retry Time
EMS: Subscribe Retry Time
[SubscribeRetryTime]
Defines the subscription retry time (in seconds) after last
subscription failure.
The default is 120 seconds. The range is 10 to 2,000,000.
Web: Subscription Mode
[SubscriptionMode]
Deter
mines the method the device uses to subscribe to an MWI
server.
 [0] Per Endpoint = (Default) Each endpoint subscribes
separately - typically used for FXS interfaces.
 [1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
EMS: ETSI VMWI Type One
Standard
[ETSIVMWITypeOneStandard]
Determines the ETSI Visual Message Waiting Indication
(VMWI) Type 1 sub-standard.
 [0] = (Default) ETSI VMWI between rings

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet