AUMA Aumatic AC 01.1 User Manual

E2PROM ERROR
Remedy: Exchange MWG.
NOT CALIBRATED
Remedy: Re-calibrate MWG (can only be performed in the factory).
NO POSITION REFEREN.
Remedy: Re-calibrate MWG (can only be performed in the factory).
TORQUE SYSTEM FAULT
Remedy: Exchange MWG.
NO ENDPOSITIONS
Remedy: Re-set limit end positions (can only be performed in the factory).
NO TORQUE LIMITS
Remedy: Re-set torque pivot points (can only be performed in the factory).
DP1 hardware version (DC)
È
Description of the display:
DP1 HRDWR.VER.
Hardware version of the Profibus DP interface
DP1 software version (DD)
È
Description of the display:
DP1 SFTWR.VER.
Software version of the Profibus DP interface
DP1 bus status (DE)
È
Description of the displays:
BAUD SEARCH
The Profibus DP interface searches a baud rate. If no baud rate is found:
connect DP cable, check, switch on DP master
BAUD CONTROL
The detected baud rate is monitored. The DP watchdog in the master is not
activated. Thus, the failure function is available
102
Actuator controls
AUMATIC AC 01.1/ACExC 01.1 Profibus DP Manual


DP1 BUS STATUS DE


DP1 SFTWR.VER. DD


DP1 HRDWR.VER. DC

AUMA Aumatic AC 01.1 Specifications

General

Brand	AUMA
Model	Aumatic AC 01.1
Category	Control Unit
Language	English