AUMA Aumatic AC 01.1 - Page 99

Internal warnings (D3)
È
Description of the displays:
NO INTERNAL WARNING
No internal warnings have occurred
NO FACTORY PARAMS
No valid factory settings are available.
Configuration fault (D4)
È
Description of the displays:
NO FAULT
AUMATIC has been correctly configured.
END POSITION INPUTS
The LIMIT/TORQUE-SWITCH parameter setting does not correspond to
the
ENDPOS. INPUTS parameter configuration (can only be modified by
the AUMA service).
NO SWITCHING OFF
The LIMIT/TORQUE-SWITCH parameter setting does not correspond to
the
CONTROL UNIT ) parameter configuration (can only be modified by the
AUMA service).
Hardware version of the logic (D5)
È
Description of the display:
LOGIC HRDWR. VER.
Display of hardware version of the logic
99
Actuator controls
Manual AUMATIC AC 01.1/ACExC 01.1 Profibus DP


INTERNAL WARNING D3
NO INTERNAL WARNING


CONFIGURATION FAULT D4
NO FAULT


LOGIC HRDWR. VER D5