76-00-20 Glow Plug Control
76-00-21 Removal of the Glow Plug Control
1. Remove the plug connection [1] (GPC).
2. Remove the screws [2].
3. Remove the glow control box [3].
76-00-22 Installation of the Glow Plug Control
1. Use only new stop nuts.
2. Fit on the glow control box [3].
3. Torque the nuts with 4 Nm.
4. Fit the connector (GPC) [1]
5. Perform an engine ground run according to Chapter 71-00-03.
Fig. 76 - 1
To Next Page
Loading...