Chapter 05-00-00 Time Limits and Maintenance Check
05-00-01 General
Work on the engine must be conducted by a certificated mechanic or otherwise authorized persons
under consideration of the applicable national requirements. For warranty reason all of the tasks
described in this manual must be performed by trained personnel only.
All applicable national and international regulation must be observed.
In the present Maintenance Manual the correct maintenance of the aircraft engine AE 300 is
documented.
With the publication of the Maintenance Manual, Austro Engine GmbH ensures the correctness of
the instruction. In case of changes Austro Engine GmbH will inform with Service Bulletins, Service
Letters or manual amendments, if it is necessary.
If there are any problems with the maintenance and repair or any further questions about the engine,
Austro Engine GmbH can be contacted.
The aircraft engine has to be maintained and repaired in accordance with the instructions given in this
manual unless otherwise approved under consideration of the applicable national requirements.
It is necessary to read this instructions attentive and carefully. To grant a proper engine work and to
obtain the maximum service life all work steps have to be done as shown.
For any further information Austro Engine GmbH can be contacted.
The following symbols and warning signs are used in this manual to point out important instruction.
They must be observed strictly to prevent personal injury and material damage, to insure operational
safety of the aircraft and to avoid any damage to the aircraft as a result of incorrect handling.
Disregarding these safety rules can cause personal injury or even death.
Disregarding these special instruction and safety measures can damage the engine or
other components.
The maintenance intervals must be strictly observed. When the service is not executed in accordance
to this manual Austro Engine GmbH will reject any warranty claims.
Additional note or instruction for better understanding of an instruction.