85-40-00 Reciprocating Engine Rear Section
85-40-10 V-Ribbed Belt
85-40-11 Removal of the V-Ribbed Belt
1. Move the v-belt tensioner [1] clockwise by turning the screw [2] to release the belt
tension
2. Secure the v-belt tensioner with a locking pin [3].
3. Remove the v-ribbed belt [4].
85-40-12 Installation of the V-Ribbed Belt
1. Fit the v-ribbed belt [4] as illustrated in the diagram.
Make absolutely sure that the belt is routed as shown in the diagram.
No other routing is allowed.
Make sure that the ribbed side of the v-ribbed belt is facing inward.
In addition make sure that the ribs of the belt match the rills on the wheel.
The belt must lie within the boundaries of the wheel
2. Move the v-belt tensioner [1] clockwise by turning the screw [2]
3. Remove the locking pin [3].
The correct v-belt tension will be set automatically
4. Perform an engine ground run according to Chapter 71-00-03.
Fig. 85 - 93 Fig. 85 - 94
To Next Page
Loading...