71-50-900 Repair of the Engine Wiring Harness E4A-95-000-000 und E4B-95-000-000
Herein described repair procedures for exchange of connectors can only be conducted once.
71-50-901 Exchange of Connector of Gearbox Temperature Sensor (GBTS), Fuel
Temperature Sensor (FTS), Coolant Temperature Sensor (CTS) and Glow Plug Coolant
Temperature Sensor (CTS_GPC).
Cut off the referring connector as close as possible
at the end of the wiring branch.
Strip the insulation of the remaining single wires of
the engine wiring harness as shown below.
Step 3:
The length of the repair kit cable can be reduced
as required, for repair. The maximum length for
extension is as follows:
Strip the insulation of the repair kit cable as shown
below.
Place the isolation sleeve over the single wires of the
repair kit cable.
To Next Page
Loading...
Need help?
General
