Austro Engine AE330 - Exchange of Connector to Fuel Pressure Sensor (FPS)

Maintenance Manual
E4.08.04
Issue date: 14-Apr-2015
Page: 71-51
Revision no: 25
71-50-802 Exchange of Connector to Fuel Pressure Sensor (FPS)
Pos.
Partnumber
Description
Qty.
1
E4A-90-R18-000
Assy Repair Kit Cable
1
2
E4A-95-100-000
Assy Shielding Fuel Pressure
1
3
-
Cutter
1
4
-
Hot Air Gun
1
5
-
Crimp Tool for
TE (Tyco)D-436-36 crimp
1
Step 1:
Cut off the old connecter
Step 2:
Remove the black and white cable insulation.
Step 3:
Remove the shielding as shown below.
Step 4:
Put the solder sleeve over the engine harness cable
and place it above the shielding.
Heat the solder sleeve (300°C – 350°C) with a hot air
gun until the solder sleeve is connected with the
cable and the shielding
20 mm (+5mm)
Remaining
engine wiring
harness
50 mm (±5)
10 mm (+5mm)
Solder Sleeve