Mechanical Inspection:
To control the mechanical function the two-mass-flywheel has to be tested in a special testing rig –
AEP-0061. The wheel is build up and fixed with its primary mass and loaded with defined torque
loads. The deflection between the primary and secondary mass will be measured at the defined
torque (see Table 1) and recorded.
Fig. 85 - 50 Flywheel fixing adapter
At first the two-mass-flywheel will be attached in the fixing adapter of the test rig.
Thereafter a hub is attached at the connecting flange of the secondary mass and the bearing support
of the test rig is mounted as seen.
To Next Page
Loading...
