Replacing the SAMP on the Avaya S8500B server
03-300529 Issue 4 January 2008 127
All ports are located on the rear of the server. See Table 4.
See (Figure 37: S8500 B network interface card connections
on page 127) for the Ethernet port
locations on the NIC.
Figure 37: S8500 B network interface card connections
For more information see Ethernet interface mapping on page 155.
S8500B modem connections
There is one modem on an Avaya S8500B server configuration that connects to the USB port
on the SAMP (see Figure 38: Modem connections on the Avaya S8500B server
on page 128).
Required options on the SAMP modem are set by Avaya defaults on the SAMP.
Table 4: Network Interface Card Ethernet designations
Web Designation Use Mother Board Dual NIC
Eth 0 (LAN 1) CNA Eth 1
Eth 1 (LAN 2) Services laptop Eth 2
Eth 2 (LAN 3) Customer LAN Eth 1
Eth 3 (LAN 4) Not used Eth 2
Figure notes:
1. LAN 3 - to customer LAN 2. LAN 4 - not used
h2ms85b1 KLC 100504
2
1
2
To Next Page
Loading...
