Replacing the S8500/B/C server
03-300529 Issue 4 January 2008 15
7 Install the replacement
server into the rack
l S8500: see Installing the replacement S8500
server in the rack on page 32.
l S8500B: see Installing the replacement S8500B
server in the rack on page 51.
l S8500C: Installing the replacement S8500C
server in the rack on page 68.
8 Note: Skip this step if
reusing the original hard
drive.
Insert the software CD in
the CD-ROM drive of the
server, if using the blank
hard drive
Open the CD-ROM drawer and place the
Communication Manager CD in the drawer and close
it.
The software CD contains boot software that the
server automatically accesses when you power up the
server.
9 Reconnect attached
devices
Reconnect the LAN connections to the Ethernet ports
on the RSA/SAMP and dual NIC (if used).
Reconnect all attached devices, including the laptop,
both modems, and the external flashcard reader (if
used).
10 Power up the server Plug the power cords into the server and RSA. Press
the power-control button on the front of the server.
Note: Wait at least 3 minutes for the server to
complete its power up. Watch the power-on LED on
the server.
11 Note: Skip this step if using
a new hard drive.
Test the hard drive by
logging onto the
Maintenance Web
Interface.
Connect a crossover cable to the services port on the
back of the server. Open a browser on your laptop.
Type 192.11.13.6 and press Enter to log onto the
Maintenance Web Interface as craft or dadmin. Log in
as craft or dadmin.
Under Server, click Status Summary and note the
information concerning the hard drive.
Tasks for replacing an S8500/B/C server (continued)
9
Task Description
3 of 3
To Next Page
Loading...
