Hard drive
03-300529 Issue 4 January 2008 17
7 Log off the RSA/SAMP Click Log Off.
8 Disconnect the RSA/SAMP
LAN cable
Disconnect the Ethernet RJ45 cable from the RSA/
SAMP Ethernet port.
9 Connect laptop to the
server
Connect a crossover cable to the services port on the
back of the server and wait about 3 minutes from the
time you boot up the server before trying to access the
information on the CD.
10 Clear ARP cache on laptop From a DOS command line, type arp -d
192.11.13.6 and press Enter.
11 Set display parameters (if
necessary)
At the DOS command line type telnet and press Enter.
At the Telnet prompt type unset crlf and press
Enter.
Type display and press Enter to verify that message
says Sending only CR
Type exit and press Enter to close the session.
12 Install Communication
Manager
You must install the software from the CD.
l For procedure details for an S8500, see Installing
the software on the S8500 server on page 36.
l For procedure details for an S8500B, see
Installing Communication Manager on the S8500B
server on page 53.
l For procedure details for an S8500C, see
Installing the software on the S8500C server on
page 70.
13 Log onto the Maintenance
Web Interface
Open a browser on your laptop. Type 192.11.13.6 and
press Enter to log onto the Maintenance Web Interface.
Log in as craft or dadmin.
Note: Use the initial installation login craft and the
initial password.
14 Set alarm suppression on
the server
At the Linux command line type almsuppress -y and
press Enter to enable alarm suppression.
15 Check software version on
the Maintenance Web page
Under Server, click Software Version to verify the
Communication Manager release.
16 Copy files to the server Copy the license and Avaya authentication files and the
software service pack file, if any, to the server.
Under Miscellaneous, click Download Files.
Browse to select the file for downloading and click
Download.
Final tasks for replacing an S8500/B/C server using the blank hard drive (continued)
9
Task Description
2 of 6
To Next Page
Loading...
