Job Aid: Replacing the Avaya S8500/B/C server
36 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
13. On the server, press Power and wait for the operating system to come up.
14. Open a web browser to the RSA card and in the Address field, type 192.11.13.6 and
press Enter.
15. In the Enter Network Password window, in the User Name field, type craft and in the
Password field, type the password:
l If the RSA is from the replacement server, type the default password.
l Otherwise, type the same password as the server.
Press Enter.
This RSA card is new to the S8500 server and has not been configured for the customer.
16. On the Welcome window, click Continue.
17. On the navigation pane, click System Health.
18. On the System Health Summary section, monitor the Server State field until it changes to
“OS booted.” Verify “Server is operating normally” is green.
Periodically refresh the screen by clicking System Health on the navigation pane.
If the "Server is operating normally" changes from green to red before the Server State field
says "OS booted," click Event Log.
Installing the software on the S8500 server
The following steps install the software on the S8500 server.
1. Connect the services laptop to services port (Eth1) on the rear of the server.
2. Connect to 192.11.13.6 and press Enter to view the first screen.
Note:
Note: To navigate on these screens, use the arrow keys to move to an option, then
press the space bar to select the option. Press Enter to submit the screen.
To Next Page
Loading...
