Replacing the S8500C server
03-300529 Issue 4 January 2008 65
Figure 14: Removing/replacing the S8500C SAMP card
2. Disconnect the cable assembly from the motherboard (see Figure 14: Removing/replacing
the S8500C SAMP card on page 65).
3. Remove the riser-card assembly by holding the narrow (interior) part of the assembly with
one hand and the other hand under the PCI support bracket near the captive screw and
pulling straight up (see Figure 14: Removing/replacing the S8500C SAMP card
on
page 65).
4. Remove the old SAMP card by pulling the card gently out of the expansion slot.
5. Carefully grasp the new SAMP by the top edges or upper corners and align it with the
opening on the PCI support bracket. Press the SAMP firmly into the expansion slot.
Figure notes:
1. Remove cable assembly from SAMP
2. Remove riser-card assembly
3. Remove SAMP from riser-card assembly
2
1
Slot 1
Slot 2
2
3
h3mss85c LAO 032306
1
3
To Next Page
Loading...
