Azbil DCP31 - Page 121

7-11
Chapter 7. PARAMETER SETUP
No. Item Code Item
Factory
Setting
User
Setting
Setting
23
C Y . 2
Output 2 time
proportional output
cycle
10 5 to 120s (relay output)
1 to 60s (voltage output)
[Note]
On models whose output 2 is neither
relay output nor voltage output,
“– – – –” is displayed and setting is not
possible.
24
C Y . 3
Unused – [Note]
“– – – –” is displayed and setting is not
possible.
25
d V -L
3-position control
deviation lower limit
5U 0 to 1000U
[Note]
On models other than 3D output mod-
els, “– – – –” is displayed and setting is
not possible.
26
d V -h
3-position control
deviation upper limit
5U
27
H Y -L
3-position control
lower limit hysteresis
5U
28
H Y -H
3-position control
upper limit hysteresis
5U
29
.-C
Motor control
method selection
0 0: MFB control (conventional) + estimat-
ed position control
1: MFB control (conventional) only
2: Estimated position control only
[Note]
On models other than 2G output mod-
els, “– – – –” is displayed and setting is
not possible.
30
.-A t
Motor valve opening
automatic adjust-
ment
0 0: Adjustment disabled
1: Adjustment enabled
[Note]
On models other than 2G output mod-
els, “– – – –” is displayed and setting is
not possible.
On 2G output models, when
.-C
setting is 2, “– – – –” is displayed and
setting is not possible.