Azbil DCP31 - E d i (event 1 to 3 standby); D L i (event 1 to 3 ON delay time)

7-23
Chapter 7. PARAMETER SETUP
No. Item Code Item
Factory
Setting
User
Setting
Setting
2
E D 1
Event 1 standby 0 0: Standby OFF
1: Standby ON
[Note]
The controller stands by after power
is restored and in the READY mode.
When the event type setting is ≥ 50,
“– – – –” is displayed and setting is not
possible.
3
H Y S 1
Event 1 hysteresis 5 0 to 200U (when event type is neither MV
nor MFB)
0.0 to 20.0 % (when event type is MV or
MFB)
[Note]
When the event type setting is ≥ 50,
“– – – –” is displayed and setting is not
possible.
4
D L 1
Event 1 ON delay
time
0 0 to 3600s