Azbil DCP31 - C 1 1 (PID set autoswitching (CH1))

7-46
Chapter 7. PARAMETER SETUP
No. Item Code Item
Factory
Setting
User
Setting
Setting
11
C 1 1
PID set autoswitch-
ing (CH1)
0 0: OFF (PID set segment designation)
1: ON
[Note]
When set to 1, the PID set items in the
program are invalid.
The switching point for auto-switching
is set in variable parameters (
C P . 1 1
to
C P . 1 7
).
12
C 1 2
MV setting at input 1
over-range (MV1)
0 0: OFF
1: ON
13
C 1 3
MV at input 1 over-
range
(MV1)
0 -10 to +110%
[Note]
When
C 1 2
setting is 0, “– – – –” is
displayed and setting is not possible.
14
C 1 4
Manual change
mode (MV1)
0 0: Bump-less
1: Preset
[Note]
When the programmer function is
selected, operation is bump-less
regardless of the setting of
C 1 4
.
15
C 1 5
Preset manual value
(MV1)
0 -10 to +110%
[Note]
When
C 1 4
setting is 0, “– – – –” is
displayed and setting is not possible.
16
C 1 6
MV in READY mode
(MV1, MV1 heat-cool
output)
0 -10 to +110%
[Note]
This setting is valid even if the pro-
grammer function is selected by
C 1 8
setting.
On heat/cool models, this setting func-
tions as the MV (heat) setting in the
READY mode.
17
C 1 7
MV (cool) in READY
mode (MV1 heatcool
output)
0 -10 to +110%
[Note]
When the model is not a heat/cool
model, “– – – –” is displayed and set-
ting is not possible.
18
C 1 8
Main output type
(CH1)
0 0: MV1 output (controller function)
1: SP1 output (programmer function)
[Note]
When the model is not a 5G output
model, “– – – –” is displayed and set-
ting is not possible.