xiv
The controller does not change to the setting entry state by
pressing in the basic display state 9-8
Items cannot be changed by pressing in program setup state
9-9
Event items cannot be displayed by repeatedly pressing
in program setup state 9-9
Time events cannot be displayed by repeatedly pressing
in program setup state 9-9
PID set items cannot be displayed by repeatedly pressing
in program setup state 9-9
G.Soak items cannot be displayed by repeatedly pressing
in program setup state 9-10
PV start items, cycle items and pattern link items cannot be dis-
played by repeatedly pressing in program setup state 9-10
Insertion/deletion of segments cannot be confirmed by pressing
+ in program setup state 9-10
Program deletion cannot be confirmed by pressing +
while entering pattern items in program setup state 9-10
The program cannot be copied by pressing + in the
basic display state 9-11
General reset is not applied by pressing + + in the
basic display state 9-11
9 - 4 Motor Adjustment is Impossible 9-12
Normal wiring for direct motor rotation 9-13
Normal wiring for reverse motor rotation 9-13
Alarm display caused by wrong wiring and causes 9-13
9 - 5 Replacing the Battery 9-14
BAT LED blinking 9-14
Replacing the battery 9-14
Replacement procedure 9-15
Chapter 10. DISPOSAL 10-1
Chapter 11. SPECIFICATIONS 11-1
11 - 1 Specifications
11-1
Accessories/option list 11-9
11 - 2 External Dimensions 11-10
Soft dust-proof cover set (sold separately) 11-11
Hard dust-proof cover set (sold separately) 11-11
Terminal cover set (sold separately) 11-12
China RoHS 11-12
To Next Page
Loading...
