Azbil DCP31 - Keys

2-5
Chapter 2. NAMES & FUNCTIONS OF PARTS

Keys
Category Function Key operation
Basic display state To change the display
DISP
To change the program No. in ascending order
(in READY mode)
PROG
To execute running of program
(in READY mode)
To run the program
(in READY, HOLD, FAST modes)
RUN/HOLD
To hold the program
(in RUN mode)
To reset the program
(in READY, HOLD, FAST, END modes)
PROG
+
RUN/HOLD
To advance the program
(in RUN, HOLD, FAST modes)
PROG
+
DISP
To run the program fast
(in RUN, HOLD modes)
FUNC
+
To execute manual operation
(in AUTO mode)
A/M
To execute automatic operation
(in MANUAL mode)
To start auto-tuning
(when not executing auto-tuning)
AT
To cancel auto-tuning
(when executing auto-tuning)
To change values during manual operation
(when MV or SP is blinking)
: Program key
: Function key
Loader jack
: Auto/Manual key
: Auto-tuning key
: Parameter key
PROG
FUNC
A/M
AT
PARA
: Enter key
ENT
: Clear key
CLR
: Run/Hold key
RUN/HOLD
: Display key
DISP
: Left arrow key, right arrow key
: Up arrow key, down arrow key