Azbil DCP31 - Safety Requirement; Equipment Installation

i
Safety Requirement
To reduce the risk of an electric shock resulting in personal injury, follow all safety no-
tices in this document.
This symbol warns the user when there is a danger of electric shock from accidental
contact.
•Theuseofthisproductinamannernotspecifiedbythemanufacturerwillimpairitsbuilt-insafety
features.
•Donotreplaceanycomponentorpartnotexplicitlyspecifiedasreplaceablebythemanufacturer.
•Allwiringmustbeinaccordancewithlocalregulationsandcarriedoutbyauthorizedandexperi-
encedpersonnel.
•Tobesafe,besuretowirethegroundterminalbeforeotherwiring.
•Besuretomountaswitchforshutoffofthemainpowertothisdevicewithinreachoftheoperator.
•Connectatime-lagfusewitharatedcurrentof1.0Aandratedvoltageof250Vtothewiringforthe
devicepowersupply.(Reference:IEC127)
•Thefusemustbeconnectedtothewiringonthenon-groundedside.
•Ifafuseisneeded,pleaseusethefollowing.
Manufacturer:Littelfuse,Inc.
ModelNo.: 218001
Rating: 250Vac,1A
 EQUIPMENT RATINGS
Supplyvoltage: 100to240Vac(operatingsupplyvoltage:90to264Vac)
Frequency: 50/60Hz
Powerconsumption: 30VA max.
 EQUIPMENT CONDITIONS
Donotusethisdevicenearflammablefluidsorvapors.Undersuchcircumstances,safetywillbe
impaired.
Operatingtemperature: 0to50°C
Operatinghumidity: 10to90%RH(withoutcondensation)
Vibration: 1.96m/s
2
max.(10to60Hzfor2heachinx,y,andzdirections)
Overvoltage: CategoryII(IEC60364-4-443,IEC60664-1)
Pollutiondegree: 2
Installationlocation: Indoors
Altitude: 2000mmax.
 EQUIPMENT INSTALLATION
•Besuretomountthisdeviceinapanelsothatoperatorsdonottouchtherearterminalblock.
•Withtheexceptionofsupplypowerandrelaycontactoutput,theI/Ocommonmodevoltage
withrespecttothegroundshouldbe33VRMSmax.,46.7Vpeakmax.,and70Vdc max.
 STANDARDS COMPLIANCE
EN61010-1,
EN61326-1(Foruseinindustriallocations)
DuringEMCtesting,thereadingoroutputmayfluctuateby±10%FS.
However,theMFB(motor-openingfeedback)iswithin±30%FS.
WARNING
There is a danger of explosion if the battery is incorrectly replaced.
When replacing the battery, use only the type specified in this user's manual or an equivalent type.
Dispose of used batteries according to the manufacturer's instructions.