Azbil DCP31 - Page 68

5-4
Chapter 5. FUNCTIONS
• Segmentprogression
 - OutputisOFFuntiltheprogramprogressestothesegment
containingtheeventsetting.
 - Whentheprogramprogressestothesegmentcontainingthe
eventsetting,eventON/OFFoperationiscarriedoutaccording
totheeventsettingvalue.
 - Theprevioussettingisvaliduntiltheprogramprogressestoa
segmentcontaininganeweventsetting.
  Forthisreason,setasfollowstodisabletheeventsetinthe
previoussegmentfromacertainsegmentonwards:
   Directactionevents: Upperlimitvalueofeventsetting
   Reverseactionevents: Lowerlimitvalueofeventsetting
  Note,however,thatsometypesofeventturnONevenifevents
aresetasshownabove.
  -WhentheprogramhasprogressedtotheNo.1segmentby
thecycleorpatternlinkfunctions,theprevioussettingis
disabled.OutputisOFFunlesstheNo.1segmentcontainsan
eventsetting.
• Other
 On5Goutputmodels,whensetupdataC18issetto1,andSP
output(programmerfunctions)isselected,theMVdirect/reverse
eventdoesnotfunction.