Azbil DCP31 - AUTO; MANUAL

5-17
Chapter 5. FUNCTIONS

END
Inthismode,operationoftheprogramhasended.
MVoutputsareactiveinPIDcontrolorON-OFFcontrol,and
eventsandtimeeventsareactivewithprogramoperationstoppedat
theprogramendpoint.
TheENDmodeisnotavailableduringconstant-valueoperation.

AUTO
Inthismode,programoperationisautomatic.
MVoutputisactiveaccordingtocontrollercontrol.
(However,notethatwhenprogrammerfunctionsareselectedon5G
outputmodels,SPoutputisactiveaccordingtocontrollercontrol.)

MANUAL
Inthismode,programoperationismanual.
MVoutputcanbechangedby
, , , ontheconsole
orcommunications.
(However,notethatwhenprogrammerfunctionsareselectedon5G
outputmodels,SPoutputcanbechangedby
, , , 
ontheconsoleorcommunications.)