Azbil DCP31 - Page 84

5-20
Chapter 5. FUNCTIONS

MANUAL
ThisoperationinvolvesshiftingtotheMANUALmodefromthe
AUTOmode.
WhentheDCP31enterstheMANUALmode,thebasicdisplaystate
changesasfollows.
- Whencontrollerfunctionsareselected,PVandoutputvalue(%)
aredisplayed.
- Whenprogrammerfunctionsareselected,PVandSParedisplayed.
WhentheDCP31enterstheMANUALmodefromtheAUTOmode
byexternalswitchinputsorcommunications,thedisplaychangesto
thebasicdisplaystateevenintheparametersetuporprogramsetup
states.

Program end
WhenoperationprogressesintheRUNorFASTmodesinthe
programoperationmode,orwhenthesegmenthasbeenadvanced
intheADVmode,theprogramendswhenallendpointsinthepro-
gramsetupincludingcyclesandpatternlinkshavebeenreached.
YoucanselectinthesetupsettinginwhichoftheREADYorEND
modesprogramoperationends.
Theprogramdoesnotendintheconstant-valueoperationmode.