Azbil DCP31 - Page 99

6-5
Chapter 6. OPERATION

Display 6
Whentheremainingnumberofcyclesis“0”,subsequentcycle
operationisnotcarriedout.

Display 7
ThedigittowhichSPvaluescanbeenteredblinksintheMANUAL
modewhenprogrammerfunctionsareselected.Eitherof“h:min”
or“min:s”isselectedasthetimeunitinsetupsettings.Selecteither
“remainingsegmenttime”or“totaloperatingtime”insetupset-
tingsasthedetailswhosetimeistobedisplayed.
PV
CYC
PV
Number of remaining cycles
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5
SP
TM
SP
Time
Program No. Segment No.
Pattern
tendency
Output states of events 1 to 3, time events 1 to 5