B&R Automation PC 620 - CAN Node Number (Only APC620 Embedded); CAN Terminating Switch; LED (Only APC620 Embedded)

Technical data • Entire device
Section 2
Technical data
107Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.13.5 CAN node number (only APC620 embedded)
2.13.6 CAN terminating switch / LED (only APC620 embedded)
CAN node number switch (x1, x16) - only APC620 embedded
Both of these hex switches (x16, x1) are used to configure the
node number for the CAN interface.
Switch position
x16 x1 Description
0 ... F 0 ... F Any
Table 34: CAN node number switch (x1, x16) - only APC620 embedded
CAN terminating switch / LED (only APC620 embedded)
CAN networks are cabled using a bus structure where both ends
of the bus are equipped with terminating resistors.
The APC620 embedded has an integrated terminating resistor
(delivery state: disabled with the setting "Off").
LED On Off
Yellow The terminating
resistor integrated
in the bus
controller is
turned on.
The terminating
resistor integrated
in the bus
controller is
turned off.
CAN terminating
switch
Position
Off
Position
On
Can be pressed
using a pointed
object.
Terminating
resistor is turned
off.
Terminating
resistor is turned
on.
Table 35: CAN terminating switch / LED (only APC620 embedded)
CAN terminating switch
CAN terminating LED