B&R Automation PC 620 - Installation for Dual Display Clone

Software • Automation PC 620 with Windows XP Professional
Section 4
Software
361Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
6.3.2 Installation for Dual Display Clone
• Executing setup
• The Automation Panel 900 unit's touch screen is connected with the APC620 serially, so
the serial touch screen drivers must be installed.
• The driver's auto-detect function sends data packets to every existing serial interface. It
then returns a list of all the ports on which an Elo touch screen is connected. The panel
locking time must be set to 0 ms (auto-detect only found 1 touch screen)
Information:
• Activate COM C in BIOS.
• During installation the panel locking time must be set to 0 ms ("Auto detect" of the driver
could only recognize 1 touch screen).
Figure 167: Touch screen driver - serial touch screen
Figure 168: Touch screen driver - auto-detect