528
Maintenance / Servicing • Installing the UPS module
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
4.2.3 APC620, 5 PCI slot
• Remove side cover (see section 5 "Mounting the side cover", on page 531).
• Remove UPS module cover by removing the 2 marked Torx screws (using T10
screwdriver).
• Remove cover plate by removing the marked Torx screw (T10).
• Screw in spacing bolt (using M5 hex socket screwdriver).
Figure 306: Remove UPS module cover
Figure 307: Remove cover plate
Figure 308: Screw in spacing bolt
To Next Page
Loading...
