B&R Automation PC 620 - AP Link Cards; Accessories; Supply Voltage Connectors; X2 X and CAN Plugs

30
General information • Model numbers
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
5.8 AP Link cards
5.9 Accessories
5.9.1 Supply voltage connectors
5.9.2 X2X and CAN plugs
5.9.3 Batteries
5.9.4 CompactFlash cards
Model number Short description Note
5AC600.SDL0-00 AP Link SDL transmitter
APC620 Smart Display Link Transmitter, to connect an Automation Panel via SDL to an
APC620.
See page 197
Table 11: Model numbers - AP Link graphics adapter
Model number Short description Note
0TB103.9 Plug 24V 5.08 3-pin screw clamps
24 VDC 3-pin connector, female. Screw clamp, 3.31mm²; protected against vibration by the
screw flange.
See page 415
0TB103.91 Plug 24V 5.08 3-pin cage clamps
24 VDC 3-pin connector, female. cage clamps, 3.31mm²; protected against vibration by the
screw flange.
See page 415
Table 12: Model numbers - Supply voltage connectors
Model number Short description Note
0TB704.9 Terminal block, 4-pin,
Screw clamp, 1.5 mm²
See page 417
0TB704.91 Terminal block, 4-pin,
cage clamps, 2.5 mm²
See page 417
Table 13: Model numbers - X2X and CAN plug
Model number Short description Note
0AC201.91 Lithium batteries, 4 pcs.
Lithium batteries, 4 pcs., 3 V / 950 mAh, button cell
See page 418
4A0006.00-000 Lithium battery, 1 pc.
Lithium batteries, 1 pcs., 3 V / 950 mAh, button cell
See page 418
Table 14: Model numbers - Batteries
Model number Short description Note
5CFCRD.0512-04 CompactFlash 512 MB B&R
CompactFlash card with 512 MB SLC NAND flash and IDE/ATA interface
See page 422
Table 15: Model numbers - CompactFlash cards