Maintenance / Servicing • Mounting the side cover
Section 7
Maintenance / Servicing
531Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
5. Mounting the side cover
The number of Torx (T10) screws varies depending on the system (1, 2, 3 or 5 PCl slots).
5.1 APC620 with 1 PCI slot
• Disconnect the power supply to the Automation PC 620.
• Touch the housing or ground connection (not the power supply!) in order to discharge any
electrostatic charge from your body.
• Open the orange front cover. Behind the cover there are 3 Torx screws (T10) that must
be removed.
• After the screws have been removed, the side cover can be removed by sliding it toward
the front.
Figure 313: Mounting the side cover - APC620, 1 PCI slot
To Next Page
Loading...
