B&R Automation PC 620 - Connection of an External Device to the Main Board

542
Appendix A • Connection of an external device to the main board
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2. Connection of an external device to the main board
A plug on the main board enables branching of +5 VDC and +12 VDC for the internal supply of
e.g. special PCI cards.
The connector is only provided starting with the following system unit revisions:
The voltage can be accessed using the "APC620 internal supply cable 5CAMSC.0001-00", on
page 446. Depending on the system unit revision, the connector is located close to the fan
connector. The APC620 side cover and possibly also the slide-in drive and PCI cards must be
removed to reach the connector.
Model number Short description Starting with revision
5PC600.SX01-00 System 1 PCI B7
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot B0
5PC600.SX02-01 System 2 PCI, 1 disk drive slot B9
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot A0
5PC600.SX05-01 System 5 PCI, 2 disk drive slots A0
Table 331: Revision information for connecting an external device
Figure 325: Connector location for external devices
Fan connection
Fan connection
External devices
External devices