Technical data • Entire device
Section 2
Technical data
111Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.13.11 Ethernet connection ETH1
This Ethernet connection is integrated in the CPU board being used.
Driver support
A special driver is necessary for operating the Intel Ethernet controller 82562. Drivers for
Windows XP Professional, Windows XP Embedded, and DOS are available for download on the
B&R Homepage in the download area (www.br-automation.com
).
Ethernet connection (ETH1
1)
)
1) The interfaces, etc. available on the device or module were numbered accordingly for easy identification. This numbering can differ from
the numbering used by the particular operating system.
Controller Intel 82562
RJ45 twisted pair (10BaseT/100BaseT), female
Cabling S/STP (Cat5e)
Transfer rate 10/100 MBit/s
2)
2) Both operating modes possible. Change-over takes place automatically.
Cable length See table 43 "Ethernet cable lengths
when using 5PC600.X945-00 CPU
boards", on page 112.
LED On Off
Green 100 Mbit/s 10 Mbit/s
Orange Link
(Ethernet network
connection
available)
Activity (blinking)
(Data transfer in
progress)
Table 42: Ethernet connection (ETH1)
Information:
Required drivers can only be downloaded from the B&R homepage, not from
manufacturers' pages.
To Next Page
Loading...
