Technical data • Entire device
Section 2
Technical data
143Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.13.33 Slide-in slot 2 drive slot
The "slide-in slot 2" drive slot exists only in APC620 system units with 5 PCI slots. It is possible
to insert a number of slide-in drives into it. See table for available slide-in drives 8 "Model
numbers - Drives", on page 28.
For instructions about installing and replacing a slide-in, see chapter 7 "Maintenance /
Servicing", section 3 "Slide-in drive - installation and exchange", on page 511.
The slide-in USB FDD drive (5AC600.FDDS-00) is referred to as USB.
2.14 Serial number sticker
Each B&R device is assigned a unique serial number label with a bar code (type 128), which
allows the device to be clearly identified.
Information:
• It is possible to add or remove a slide-in drive at any time.
• In system units with 5 PCI slots, the slide-in USB FDD (5AC600.FDDS-00)
drive must be inserted in slide-in slot 1 for mechanical reasons.
Caution!
Turn off power before adding or removing a slide-in drive.
Slide-in slot 2
Connection USB
Accessories Short description
5AC600.FDDS-00 Slide-in USB FDD
Table 72: Technical data - Slide-in slot 2
To Next Page
Loading...
