B&R Automation PC 620 - An AP900 and an AP800 Via SDL (Onboard); Basic System Requirements; Cables

Commissioning • Connection examples
Section 3
Commissioning
227Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
4.5 An AP900 and an AP800 via SDL (onboard)
An Automation Panel 900 and an Automation Panel 800 are connected to the integrated SDL
interface (onboard) via SDL.
USB is supported up to a maximum distance (segment 1 + segment 2) of 30 m on the two
displays. Starting at a distance of 30 m, USB is only available on the first display (front and back)
up to a maximum of 40 m. USB devices can only be connected directly to the Automation Panel
900 or extension keyboard (without a hub).
4.5.1 Basic system requirements
The following table shows the possible combinations for the APC620 system unit with CPU
board to implement the configuration shown in the figure above. If the maximum resolution is
limited when making the combination then it is also shown in this table.
4.5.2 Cables
How to select an SDL cable for connecting the AP900 display to the AP900 display 4.3 "An
Automation Panel 900 via SDL (onboard)".
How to select an SDL cable for connecting the AP800 display to the AP900 display4.4 "An
Automation Panel 800 via SDL (onboard)".
Figure 98: Configuration - One AP900 and an AP800 via SDL (onboard)
CPU board with system unit
Restriction
Resolution
5PC600.SX01
-00
5PC600.SX02
-00
5PC600.SX02
-01
5PC600.SF03
-00
5PC600.SX05
-00
5PC600.SX05
-01
5PC600.SE00
-00 / -02
5PC600.X945-00 ✓ - ✓ --✓✓Max. UXGA
Table 131: Possible combinations of system unit and CPU board
✓ ✓
✓
✓
USB OK
0
Automation PC 620
5AC600.SDL0-00
SDL segment 1
max. 40 m
Link: 5DLSDL.1000-01
Graphics Engine 1
x
Internal APC620 panel number
SDL segment 2
max. 40 m
Monitor / panel
connection
Automation Panel 800
1
USB
possible
2
4
3
Independent of segment length Depends on segment length