B&R Automation PC 620 - APC620, 2 PCI Slot

Maintenance / Servicing • Installing the UPS module
Section 7
Maintenance / Servicing
517Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
4.1.2 APC620, 2 PCI slot
• Remove side cover (see section 5 "Mounting the side cover", on page 531).
• Remove UPS module cover by removing the 2 marked Torx screws (T10).
• Remove cover plate by removing the marked Torx screw (T10).
• Screw in spacing bolt and spacing ring (using M5 hex socket screwdriver).
• Install mounting bracket on UPS module using 2 Torx screws (T10).
Figure 280: Remove UPS module cover
Figure 281: Remove cover plate
Figure 282: Screw in spacing bolt and spacing ring
14 mm spacing bolt
+ spacing ring