B&R Automation PC 620 - APC620, 5 PCI Slot

520
Maintenance / Servicing • Installing the UPS module
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
4.1.3 APC620, 5 PCI slot
• Remove side cover (see section 5 "Mounting the side cover", on page 531).
• Remove UPS module cover by removing the 2 marked Torx screws (T10).
• Remove cover plate by removing the marked Torx screw (T10).
• Screw in spacing bolt and spacing ring (using M5 hex socket screwdriver).
• Install mounting bracket on UPS module using 2 Torx screws (T10).
Figure 287: Remove UPS module cover
Figure 288: Remove cover plate
Figure 289: Screw in spacing bolt and spacing ring
16 mm spacing bolt
+ spacing ring