B&R Automation PC 620 - Technical Data; Flex Radius Specification

448
Accessories • Cables
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
12.2.2 Technical data
12.2.3 Flex radius specification
Features 5CADVI.0018-00 5CADVI.0050-00 5CADVI.0100-00
Length
Tolerance
1.8 m
±30 mm
5 m
±50 mm
10 m
±100 mm
Cable diameter
Maximum 8.5 mm
Shielding Individual cable pairs and entire cable
Connector type
Connection cycles
2x DVI-D (18+1), male
100
Wire cross section AWG 28
Line resistance Max. 237 Ω/km
Insulation resistance Min. 100 MΩ/km
Flexibility Limited flexibility; valid for ferrite magnet - ferrite magnet (tested 100 cycles with 5x cable diameter, 20 cycles /
minute)
Flex radius
Fixed layout
See figure "Flex radius specification", on page 448
5x cable diameter (plug - ferrite magnet and ferrite magnet - ferrite magnet)
Weight Approx. 300 g Approx. 590 g Approx. 2100 g
Table 302: Technical data - DVI cable 5CADVI.0xxx-00
Figure 201: Flex radius specification
Plug
Ferrite
Ferrite
Ferrite
Flex radius
Plug - Ferrit
Flex radius
Ferrite - Ferrite