B&R Automation PC 620 - Installing the UPS Service for the B&R APC Add-On UPS

Software • B&R Automation Device Interface (ADI) driver - Control Center
Section 4
Software
377Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
10.4.1 Installing the UPS service for the B&R APC add-on UPS
1) Open the Control Center in the Control Panel.
2) Select UPS tab.
3) Click on System under UPS settings. This opens the Power Options in the Control Panel.
(The Power Options can also be opened directly from the Control Panel.)
4) Select the UPS tab and click Select....
5) Choose 'Bernecker + Rainer' as manufacturer and 'APC Add-On UPS' as model and then
click Finish. The value for the COM connection is only required for a serially connected UPS
and is ignored by the APC add-on UPS driver.
6) Click on Apply to begin UPS operation. After a few seconds the UPS status and details are
displayed.
Figure 174: ADI Control Center - UPS settings
Caution!
The installed UPS must be selected and configured in the Control Panel using the
energy options in order for battery operation to be supported.
Information for Windows XP Embedded:
The UPS service is supported starting with B&R Windows Embedded Version 2.10
or higher.