Maintenance / Servicing • Replacing the front cover
Section 7
Maintenance / Servicing
539Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
7.2 Variation B - Front cover attached without screws
• A label on the side of the hinge bar "PULL TO REMOVE" indicates that the front cover is
attached without screws.
• Open the front cover approximately 1-2 cm. Now remove the cover by pulling it in the
direction of the red arrow.
Figure 321: APC620 front cover label
Figure 322: Removing the APC620 front cover
To Next Page
Loading...
