EasyManua.ls Logo

B&R Automation PC 620 - Battery

B&R Automation PC 620
594 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical data • Entire device
Section 2
Technical data
139Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
2.13.30 Battery
The lithium battery (3 V, 950 mAh) buffers the internal real-time clock (RTC) as well as the
individually saved BIOS settings and is located behind the black cover. The buffer duration of the
battery is at least 4 years (2½ years with the SRAM module model number 5AC600.SRAM-00
or with an APC620 embedded system unit and at 50°C, 8.5 mA current requirements of the
supplied components and a self discharge of 40%). The battery is subject to wear and should be
replaced regularly (at least following the specified buffer duration).
For more on changing the lithium battery, see chapter 7 "Maintenance / Servicing", section
"Changing the battery", on page 493.
For technical information on the lithium battery, see chapter 6 "Accessories", section 4
"Replacement CMOS batteries", on page 418.
Battery status evaluation
The battery status is evaluated immediately following start-up of the device and is subsequently
checked by the system every 24 hours. The battery is subjected to a brief load (1 second) during
the measurement and then evaluated. The evaluated battery status is displayed in the BIOS
Setup pages (under Advanced - Baseboard monitor) and in the B&R Control Center (ADI driver),
but can also be read in a customer application via the ADI Library.
Battery
Battery
Type
Removable
Lifespan
Renata 950 mAh
Yes, accessible from the
outside
4 years
1) 2)
1) At 50°C, 8.5 µA of the supplied components and a self discharge of 40%.
2) The buffer duration is 2 1/2 years if a SRAM module (Mod.Nr. 5AC600.SRAM-00) is installed or in conjunction with an APC620
embedded system unit.
Accessories Short description
0AC201.91 Lithium batteries, 4 pcs.
Lithium batteries (4 pcs.),
3 V / 950 mAh, button cell
4A0006.00-000 Lithium battery, 1 pc.
Lithium battery (1 pcs.),
3 V / 950 mAh, button cell
Table 67: Technical data - battery
Battery status Meaning
N/A Hardware, i.e. firmware used is too old and does not support read.
GOOD Data buffering is guaranteed
Table 68: Meaning of battery status

Table of Contents

Related product manuals